Surge voltage arrester, Low voltage, Accessories, Spare arrester, TT only for N-PE
Order No.
1351930000
Type
VPU I 0 N-PE 260V/50KA
GTIN (EAN)
4050118158274
Qty.
1 pc(s).
Dimensions and weights
Depth
64 mm
Depth (inches)
2.52 inch
Height
94 mm
Height (inches)
3.701 inch
Width
17.8 mm
Width (inches)
0.701 inch
Net weight
73 g
Temperatures
Storage temperature
-40 °C...80 °C
Operating temperature
-40 °C...70 °C
Humidity
5 - 95% rel. humidity
Environmental Product Compliance
RoHS Compliance Status
Compliant without exemption
REACH SVHC
No SVHC above 0.1 wt%
General data
Number of poles
1
Protection degree
IP20
Colour
blue
Insulation coordination acc. to EN 50178
Pollution severity
2
Surge voltage category
IV
Rated data IEC / EN
Discharge current Imax (8/20µs) N-PE
100 kA
Discharge current In (8/20µs) N-PE
50 kA
Energy coordination (≤10 m)
Type I, Type II, Type III
Frequency range, max.
60 Hz
Frequency range, min.
50 Hz
Fuse
Not required
Leakage current at Un
1 µA
Lightning test current, Iimp (10/350 µs) (N-PE)
50 kA
Low voltage network
TT only for N-PE
Max. continuous voltage, Uc (N-PE)
260 V
Number of poles
1
Protection level Up at IN (N-PE)
≤ 1.5 kV
Rated voltage (AC)
230 V
Requirements category acc. to IEC 61643-11
Type I, Type II
Requirements class, acc. to EN 61643-11
T1, T2
Response time
≤ 100 ns
Short-circuit current rating ISCCR
25 kA
Standards
IEC61643-11, EN61643-11
Temporary surge voltage (over-voltage) - TOV
1,200 V
Voltage type
AC
Connection data
Type of connection
pluggable
Electrical data
Voltage type
AC
Important note
Product information
Only applicable to IT power systems where the earth on the distribution transformer is interconnected with the earth on the consumer side (RE=RA in Figure 44.A1 of IEC 60634-4-44:2018).
Spare arrestor for surge voltage arrestor VPU I 0 260 V N-PE series.The pluggable sparkover gaps made from V0 material can be replaced by trained personnel following a failure. Rated voltage: 260 V N-PE with 50 kA Type: Weidmüller VPU I 0 N-PE 260 V/50 kA Order No.: 1351930000
Short specification
Spare arrester for surge voltage arrester VPU I 0 260 V N-PE series. The pluggable sparkover gaps can be swapped by trained personnel following a failure. Rated voltage: 260 V N-PE with 50 kA Type: Weidmüller VPU I 0 N-PE 260 V/50 kA Order no.: 1351930000
Approvals
Approvals
ROHS
Conform
Related products:
Type of connection:
pluggable
Order No.:
1351940000
Type:
VPU I 0 N-PE 260V/100KA
Version:
Surge voltage arrester, Low voltage, Accessories, Spare arrester, TT only for N-PE
Only applicable to IT power systems where the earth on the distribution transformer is interconnected with the earth on the consumer side (RE=RA in Figure 44.A1 of IEC 60634-4-44:2018).
Spare arrestor for surge voltage arrestor VPU I 0 260 V N-PE series.The pluggable sparkover gaps made from V0 material can be replaced by trained personnel following a failure. Rated voltage: 260 V N-PE with 50 kA Type: Weidmüller VPU I 0 N-PE 260 V/50 kA Order No.: 1351930000
Short specification
Spare arrester for surge voltage arrester VPU I 0 260 V N-PE series. The pluggable sparkover gaps can be swapped by trained personnel following a failure. Rated voltage: 260 V N-PE with 50 kA Type: Weidmüller VPU I 0 N-PE 260 V/50 kA Order no.: 1351930000
This function is provided via the external service provider https://supplyframe.com. By clicking on "Continue" you will be redirected to this page. This leads to a data transfer of personal data to non-European countries. Please check the data protection policy of the external website, for which Weidmüller assumes no responsibility and liability.
;)
;){kind=link}